Typically, shower manufacturers offer installation services, but if you purchase your shower online, you might have to install it yourself. Besides following the installation manual carefully, DIY installation requires attention to key areas, especially when dealing with plumbing. The dimensions and hole sizes must be precise, and the correct height for the shower head is essential for comfort and usability.
Shower Installation Steps:
1. Before starting, prepare the pipe by threading it, applying pipe dope, and wrapping it with Teflon tape. Place the elbow on the pipe, apply pipe dope to the threads, wrap with hemp, and then secure it onto the nozzle.
2. When connecting the shower to the copper inlet, tighten the nut by hand first, then level and mark the mounting holes on the plate. Remove the shower, drill a 40mm diameter hole, 10mm deep, and insert the lead ring into the hole before securing it in place.
3. Make sure to use pipe dope on the copper inlet to prevent rust and oxidation. Use a wooden disc to fix the shower plate to the wall for stability.
4. When installing the shower arm, ensure it is straight and the plate is flush against the wall. Mark the position, drill a 40mm hole, insert the lead ring, and hand-tighten the nut. Finally, secure the plate to the wall using wood screws.
Important Installation Tips:
1. The height of the faucet should be between 70-80 cm from the floor, while the shower column is typically around 1.1 meters high. The distance between the faucet and the shower arm should be 10-20 cm, and the shower head should be installed between 2.1 and 2.2 meters above the ground. Always consider your bathroom’s size when choosing a shower system.
2. Ensure that the cold and hot water pipes are not connected incorrectly. Usually, the left side of the faucet is for hot water, and the right is for cold. After installation, remove any protective caps or debris that may block the fittings, let the water run freely to clear out any impurities, and then reattach them.
3. Keep all tools provided with the faucet for future maintenance. When disconnecting the water hose, avoid using Teflon tape and instead tighten by hand—using a wrench can damage the hose. For wall-mounted faucets, adjust the elbow length according to your needs to avoid unsightly exposed pipe on the wall.
4. A common setup for most households includes a handheld shower, a lift rod, a hose, and a wall-mounted shower faucet. This combination is cost-effective and versatile, suitable for both showers and bathtubs. The lift rod should be installed so that the top end is about 10 cm higher than the user's height. The hose length varies depending on personal preference—choose a longer one if you need to wash the bathroom floor, otherwise, a 125 cm hose is usually sufficient.
Small Ball Bearings,Stainless Steel Pillow Block Bearings,Stainless Steel Thrust Bearing
Yuyao Shuguang stainless steel bearing Co., LTD , https://www.shuguangbearing.com