Custom furniture acceptance to do five look
Although custom furniture meets the individual needs, there are still many problems. In order to avoid these problems, acceptance is indispensable. The following focuses on several considerations for the acceptance of custom furniture.
Look at the appearance. Check the quality of the exterior of the decorated furniture and the quality of the exterior of the inspection package door and window. Mainly to see whether the surface paint film is smooth, bright, with or without quality defects such as falling, bubbles, wrinkles; also depends on whether the color difference of the veneer is large, whether the pattern is consistent, whether there are corrosion points, dead knots, broken parts, etc.; Whether the edge sealing treatment of wood-based panel parts is strict and straight, with or without degumming, whether the surface is smooth and flat, and there is no bump.
Look at the craft. The furniture is not fine, and it can be observed from the combined part to see the rationality and firmness of the connection point between each component of the furniture. For the overall structure of the furniture, each connection point, including the connection points between horizontal and vertical, must be tight, no gaps, and no looseness. The drawers and cabinet doors should be opened and closed flexibly and returned correctly. The periphery of the glass door should be polished and clean, flexible to open and close, no collapse, scratches, symmetry of the four corners, and the position of the buckle is positive.
Look at the structure. Check if the structure of the furniture is reasonable and the frame is correct and firm. Gently push the furniture by hand. If there is a sway or a squeaking sound, the structure is not firm. To check the verticality of the furniture, also check its warpage.
Look at the size. Furniture is not only beautiful, but more important is practical. Whether the size of the furniture is ergonomic and whether it meets the specified size determines whether the furniture is convenient or not.
Sheet & Pipe Plasma Cutting Machine mainly for 3 axis 2D drawing cutting and round pipe cutting
1.This design fit for multifunction cutting requirements: both metal sheet and pipe cutting
2. Accept OEM for any pipe cutting diameter and working length. ( Normally from 100mm up to 600mm dia. )
3. Accept OEM for any table size: likes 4x4, 4x8 Plasma Cutting Table
4. Accept any materials cutting: Iron plate, Stainless steel plate, Titanium plate, Galvanized sheet, Aluminum plate, High speed steel etc
Steel Pipe Cutter,Sheet Cutting Machine,Metal Sheet Cutting Machine,Stainless Steel Cutting Machine
Jinan Huaxia Machinery Equipment CO.,Ltd , https://www.cnmetalcutting.com