Regarding the maintenance of smart door locks, you must know this knowledge.
In order to effectively extend the service life of smart door locks, it is necessary to do smart door lock maintenance work. How can I do the maintenance of smart door locks? Today, Xiaobian will introduce the knowledge about smart door lock maintenance, I hope to help everyone.
Smart door lock maintenance is not only the maintenance of the internal system structure, but also the maintenance of the appearance. Therefore, periodically wipe the surface with a clean dry cloth or paper. Do not use water, alcohol, acid or other chemicals to clean the surface. If the surface of the lock body and the handle are scratched, the trim and handle can be replaced. Another important point in maintaining smart door locks is that the door lock database system should be backed up once a month. Intelligent door lock maintenance In addition to the two days just introduced, other aspects also hope that everyone can pay attention to, such as:
Clock calibration
Whether the door lock clock is accurate or not will directly affect the use of the key card. Therefore, it should be checked regularly (using the data card). If not, it should be calibrated in time. The method is the same as setting the clock. When repairing the door lock, if the power is off for more than 10 minutes, the door lock clock should be reset after the repair.
Replacement battery
When the battery runs out to the alarm voltage, any card is inserted, and the buzzer sounds four times continuously, indicating that the voltage is insufficient. At this time, the battery should be replaced in time. Note: Always use an alkaline battery.
Backup mechanical key unlock
If the IC card key cannot be unlocked (the battery is exhausted) and the mechanical keyhole is exposed, the backup mechanical key can be used to unlock the lock. First, remove the lock cover with a special tool, and then use the mechanical key to open the lock. Remember to open the lock after the lock is opened. Repair the door locks in time.
Filling lubricant
If the lock cylinder is inflexible or cannot maintain the correct position, the lock cylinder can be filled with lubricating oil by removing the side trim and spraying the oil into the lock cylinder with oil gun (Note: oil cannot be sprayed on the motor) At the same time, turn the handle and knob by hand until the door lock is flexible (note: do not spray too much oil, as long as the lock core is flexible).
The above is a brief introduction to the knowledge about smart door lock maintenance. Through these introductions, I hope to help you learn the maintenance of smart door locks. If you want to use the smart door locks for a long service life, it is necessary to do these basic maintenance work.
0
Anfeng Magnets Manufactruing Co.,Ltd , https://www.anfengmagnetics.com