Sandblasting problem solution
2019-10-07 15:08:11
First, no sand: Sand bucket Reid sand material consumed, turn off the gas, plus sand can be.
Second, the spray gun blocked: stop gas, go to the next nozzle to see if there is no foreign matter, and if there is anything, clean the foreign matter on the line; there is to see whether the sand material is dry, sand material too wet can also cause congestion.
Third, the sand pipe is blocked: the pipe is blocked by the stolen material, stop the gas off the climate, the nozzle and nozzle cover first take off, and then open the sandblasting machine, use the high pressure gas of the air compressor to blow out foreign matter; still no effect, then Remove the pipe, clean it or replace it.
Fourth, the sand material is not wet due to sand. This cleans the spray gun nozzle, and the sand material is poured out. After drying, it can be filtered with a sieve.
V. The large amount of water generated by the compressed air of the air compressor will not only cause the sand material to wet, but also cause the sand blasting pipe wall to be wet and adhere to the sand material, and slowly block the pipeline. Therefore, it should be avoided. With dryer.
Sixth, there is no filter causing large foreign matter or uneven sand particles into the sand valve, this should first turn off the thrust device, adjust the sand valve to open, open the sand blasting machine after pressure tank rushed, with strong pressure air to foreign objects or agglomerate If the sand material is eliminated, or if it is not enough, you can only remove the sand squeezing device, put the sand out, and then retract the sand adjustment device; then filter the sand material and add it again.
7, too much sand, sand overload can also cause congestion and can not be pressurized; so add sand, we must pay attention to the appropriate amount.
Second, the spray gun blocked: stop gas, go to the next nozzle to see if there is no foreign matter, and if there is anything, clean the foreign matter on the line; there is to see whether the sand material is dry, sand material too wet can also cause congestion.
Third, the sand pipe is blocked: the pipe is blocked by the stolen material, stop the gas off the climate, the nozzle and nozzle cover first take off, and then open the sandblasting machine, use the high pressure gas of the air compressor to blow out foreign matter; still no effect, then Remove the pipe, clean it or replace it.
Fourth, the sand material is not wet due to sand. This cleans the spray gun nozzle, and the sand material is poured out. After drying, it can be filtered with a sieve.
V. The large amount of water generated by the compressed air of the air compressor will not only cause the sand material to wet, but also cause the sand blasting pipe wall to be wet and adhere to the sand material, and slowly block the pipeline. Therefore, it should be avoided. With dryer.
Sixth, there is no filter causing large foreign matter or uneven sand particles into the sand valve, this should first turn off the thrust device, adjust the sand valve to open, open the sand blasting machine after pressure tank rushed, with strong pressure air to foreign objects or agglomerate If the sand material is eliminated, or if it is not enough, you can only remove the sand squeezing device, put the sand out, and then retract the sand adjustment device; then filter the sand material and add it again.
7, too much sand, sand overload can also cause congestion and can not be pressurized; so add sand, we must pay attention to the appropriate amount.
Npk Fertilizer,High Tower Npk,Npk Compound Fertilizer,Nitrated Based Npk Fertilizer
SHANXI HUAXIN FERTILIZER CORP. , https://www.sxhuaxingroup.com