Geothermal floor function special warming and moisturizing can not be ignored
Floor insulation should be paid attention to during installation
When using geothermal floor, consumers must pay attention to the floor and floor heating step by step.
When installing, the surface temperature should be kept at around 18 °C. Before installation, the cement floor should be gradually heated up, increasing by 5 °C every day until it reaches the standard of about 18 °C. In the first 3 days after the installation is completed, this temperature should be maintained. After 3 days, the temperature can be raised as needed, and the temperature can only be raised by 5 °C per day.
Note that heating should be gradual
The first time you use geothermal heating, be careful to heat up slowly. When used for the first time, the first three days of heating should be gradually warmed up: the first day water temperature 18 ° C, the next day 25 ° C, the third day 30 ° C, the fourth day can be raised to normal temperature, that is, water temperature 45 ° C, surface temperature 28 °C ~ 30 °C. Can not heat up too fast, too fast, the floor may be cracked and twisted due to expansion.
It will be enabled again after a long time, and the heating should be step by step.
When the geothermal heating system is activated again after a long time, it should be heated as strictly as the first time.
The surface temperature cannot be too high
It should be noted that with geothermal heating, the surface temperature should not exceed 28 ° C, and the water pipe temperature should not exceed 45 ° C. If this temperature is exceeded, it will affect the service life and service life of the floor. The average family, when the room temperature reaches 22 °C in winter, is already very comfortable. If the temperature rises normally, it will not affect the use of geothermal floor.
Turn off the geothermal system, pay attention to the gradual cooling
As the seasons go through, when the weather is warm and the indoor heating system is no longer needed, it should be noted that there is also a process to shut down the geothermal system. The cooling process of the floor should be gradual and not dip. If the cooling rate is too fast, It also affects the life of the floor.
When the room is too dry, consider humidifying
The winter climate is dry, coupled with the use of geothermal heating, the floor is prone to dryness when the temperature is high for a long time. At this time, the owner needs to humidify the room to avoid dry deformation of the floor, and the moisturizing can not be ignored.
China Agglomerated Activated Carbon ,Coal Agglomerated Activated Carbon manufacturer, choose the high quality Coal Based Agglomerated Activated Carbon,Agglomerated Granular Activated Carbon, etc.
Activated Carbon is made of high-quality anthracite as a raw material. The shapes are columnar, granular, powder, Honeycomb, spherical, etc.. It has high strength, fast adsorption speed, high adsorption capacity, and larger surface area., pore structure is developed. The pore size is between Coconut Shell Activated Carbon and Wood Activated Carbon .
It is mainly used for high-end air purification, biochemical gas, chemical gas purification(such as mustard gas, sarin gas), exhaust gas purification, high-purity water treatment, wastewater treatment, sewage treatment, aquariums, direct drinking water purification, desulphurization, exhaust gas treatment, household exhaust gas(formaldehyde, etc.) purification , water treatment activated carbon denitrification and can effectively remove impurities and pollutants in gases and liquids, as well as the separation and purification of various gases, can also be widely used for the adsorption and recovery of various low-boiling point substances, deodorizing and removing oil.
Agglomerated Activated Carbon
Agglomerated Activated Carbon,Coal Agglomerated Activated Carbon,Coal Based Agglomerated Activated Carbon,Agglomerated Granular Activated Carbon
NINGXIA SINOTOPSKY INTERNATIONAL TRADING CO.,LTD. , http://www.nxsinotopsky.com